Home Improvement

Asbestos Siding Pictures: Complete Guide for Homeowners

Asbestos Siding Pictures: Complete Guide for Homeowners

Roughly 30 million American homes built between 1920 and 1980 still wear asbestos cement siding. It looks like a regular shingle from the street but behaves very differently the moment a saw blade touches it. Most homeowners go searching for asbestos siding pictures because they suspect their house might have it and they need to know before pulling permits for an exterior remodel. This guide walks through how to identify asbestos siding by sight, what to do once you confirm it, and the EPA-regulated procedures for safe handling, encapsulation, or removal.

What Asbestos Siding Looks Like

Asbestos cement shingles come in two dominant styles. The first is a flat rectangular shingle, typically 12 inches tall by 24 inches wide, with two scallops or notches cut into the bottom edge. The second is a square or diamond pattern, often 12 by 12 inches, installed on a diagonal. Both have a distinctive thickness of 1/8 to 1/4 inch and ring with a high-pitched tone when tapped, unlike modern fiber cement which produces a duller sound.

Color clues include muted gray, pale green, butter yellow, and faded white. The pigment was added to the cement slurry during manufacture, so the color extends through the full thickness rather than sitting on top. A chipped corner will show the same color as the face, unlike vinyl or wood siding where damage exposes a different substrate.

Texture is another tell. Asbestos cement was often cast with a faux wood grain or a stippled rock face. The wood grain runs in long parallel lines and looks slightly fake compared to real cedar shake. The rock face has random small bumps that feel like a coarse sandpaper under your hand.

Visual Identification Checklist

Walk the exterior and check these features:

  • Brittle, chalky surface that breaks rather than bends when pressed
  • Hairline cracks radiating from the nail head, especially on older shingles
  • Faded chalky white residue (calcium leaching) on the surface, especially on south-facing walls
  • Mortar-gray cut edges visible at corners and trim transitions
  • Distinctive nail pattern with two nails per shingle, often through small pre-drilled holes
  • Lap pattern that exposes only the bottom 8 inches of each course, leaving the top 4 inches covered by the next row

If three or more of these match, treat the siding as asbestos until lab testing proves otherwise.

Houses Most Likely to Have It

Asbestos siding hit peak popularity from 1944 to 1976. The product was marketed under brand names like Johns-Manville Transite, Eternit, Carey, and National Gypsum. If your house was built or re-sided during that window and the current siding is not vinyl, fiber cement, or aluminum, asbestos is a strong candidate.

Common installation contexts:

  • Original cladding on bungalows, ranches, and Cape Cods built 1944 to 1976
  • Re-siding over older wood lap siding from the 1920s and 1930s
  • Trim and gable accents on otherwise vinyl-sided homes
  • Garage and outbuilding siding on midcentury properties

Modern fiber cement (HardiePlank, Allura, James Hardie) looks similar at a glance but is roughly 30 years newer at most. If the house has not been touched since the early 1980s, the existing material is far more likely to be the asbestos predecessor.

Need help with your siding project? Get a free quote by phone.
📞 Call (866) 419-8279
Free, no-obligation quote · Connect with a local pro

Testing the Material

Never assume visual identification is enough. The only way to confirm asbestos content is lab analysis. Order a polarized light microscopy (PLM) test from an EPA-certified lab. Mail-in kits from EMSL Analytical, Pro-Lab, or Schneider Labs run $30 to $80 per sample with results in 5 to 10 business days.

Sample collection requires care. Wet the area with a spray bottle of water mixed with a few drops of dish soap, cut a 1-inch piece from a damaged or hidden corner using a wet utility knife (no power tools), drop it into a sealed bag, and wipe down the area. Wear an N95 respirator and disposable gloves. The EPA’s Asbestos NESHAP rule treats any material containing more than 1% asbestos as regulated.

Encapsulation Versus Removal

Asbestos siding in good condition is not dangerous as it sits on the wall. The fibers are bound in cement and stay there unless cut, drilled, or broken. The EPA actually recommends leaving intact asbestos siding alone in most cases. Two safe options exist for homes where the look needs updating:

Encapsulation: paint or coat the existing siding with an elastomeric coating. Products like Sherwin-Williams Loxon XP or Behr Premium Plus Ultra Exterior bond well to cementitious surfaces and lock the asbestos fibers in place. A two-coat application costs $3 to $7 per square foot installed and lasts 10 to 15 years.

Cover-over: install new vinyl, fiber cement, or insulated siding directly over the asbestos. Furring strips create the structural attachment surface. This approach runs $6 to $14 per square foot installed and avoids any fiber disturbance.

Removal becomes necessary only when the siding is heavily damaged, when the house structure requires sheathing repair underneath, or when local code prohibits cover-over installations.

Removal Costs and Process

Removal of asbestos siding must follow EPA NESHAP and OSHA standards. Hire a licensed asbestos abatement contractor only. Pricing ranges from $8 to $18 per square foot of siding removed. A 1,800 sq ft house with 2,400 sq ft of siding surface costs $19,000 to $43,000 for full abatement.

The process includes:

  • Wet methods throughout (no dry breaking allowed)
  • HEPA-filtered vacuum cleanup
  • Disposal in approved sealed bags labeled with the OSHA asbestos warning
  • Transport to a designated landfill that accepts asbestos waste
  • Air monitoring before and during the work

DIY removal is legal in some states for owner-occupied single-family homes but it is not recommended. The OSHA permissible exposure limit for asbestos is 0.1 fiber per cubic centimeter averaged over 8 hours. Hitting that limit during DIY work is nearly impossible.

Living With Asbestos Siding

If the siding is intact and you do not plan to remodel, leave it alone. Wash it gently with a soft brush and garden hose (no pressure washer above 1,500 psi, which can erode the cement and release fibers). Repaint with a quality acrylic latex like Sherwin-Williams SuperPaint or Benjamin Moore Aura every 8 to 12 years. Replace cracked individual shingles with salvaged matches from architectural salvage yards rather than cutting new material.

The siding itself is not the hazard. The dust generated by cutting, sanding, drilling, or breaking it is. Treat the surface as fragile and the asbestos stays safely locked inside the cement for the life of the wall.

Get Free Siding Quotes from Local Pros