Home Improvement

Cedar Outdoor Shower: Complete Guide for Homeowners

Cedar Outdoor Shower: Complete Guide for Homeowners

Rinsing off after the beach, the garden, or a swim is far more pleasant under open sky than in a crowded bathroom, and few materials suit that job better than cedar. A cedar outdoor shower uses a naturally rot-resistant, aromatic softwood that handles constant wetting, weathers to a soft silver, and stays comfortable underfoot. Building one well, though, depends less on the wood than on the details behind it: drainage, airflow, fasteners, and plumbing that survives a freeze. This guide walks through each decision.

Why Cedar Works for a Cedar Outdoor Shower

Western red cedar is the most common choice, with Alaskan yellow cedar and eastern white cedar as regional alternatives. All three contain natural oils and extractives that help the heartwood resist decay and insects, which is why cedar has long been used for shingles, siding, and boat building. The wood is also dimensionally stable, meaning it shrinks and swells less than many softwoods as it cycles between soaked and dry, so boards stay flatter and joints stay tighter.

Comfort is the other advantage. Cedar is light, stays cooler in direct sun than composite decking, and has a pleasant scent when wet. It machines cleanly, takes stain or oil well, and looks good left untreated as it weathers from reddish brown to gray.

Keep expectations realistic: rot resistance comes primarily from the heartwood. Sapwood, the pale outer layer on some boards, is far less durable. When you shop, choose boards that are mostly or entirely heartwood for parts that stay wet, such as the floor slats and the lowest wall boards.

Choosing a Location

Site selection shapes every other decision. The best spots share a few traits:

  • Near an existing water supply: An exterior wall with a hose bib or a nearby plumbing wall keeps pipe runs short and cheap.
  • Sun and breeze: Afternoon sun and moving air dry the wood between uses, which is the single biggest factor in cedar lifespan.
  • Privacy: Consider sightlines from neighbors’ upper windows, not just from the street.
  • Good drainage: Sandy or gravelly soil drains easily; heavy clay may need a larger dry well or a connection to an approved drain.
  • Distance from the foundation: Direct water away from basement walls and crawlspace vents. A shower attached to the house needs flashing and a sloped floor that sheds water outward.

Freestanding vs. Wall-Mounted Designs

A wall-mounted outdoor shower attaches to the house and uses the siding as one side of the enclosure. It is usually cheaper and simpler to plumb because the supply lines come straight through the wall. The downside is moisture against your siding, so you need a protective backer panel, proper flashing, and cedar boards spaced off the wall so the house can dry.

A freestanding enclosure sits on its own posts away from the house. It gives more freedom in placement and keeps water off the home entirely, but it requires longer underground supply lines and a sturdier framed structure. Posts are typically 4×4 or 6×6 set on concrete footings or post bases that keep end grain off the ground.

Enclosure layouts vary from a single privacy screen to a full four-sided booth with a door and a separate changing area. A comfortable shower zone is about 3 by 3 feet at minimum, with 4 by 4 feet or larger feeling noticeably less cramped. Adding a 3-by-3-foot changing area with hooks and a bench turns a rinse station into a genuine outdoor bath.

Framing and Board Details That Make It Last

Water management is everything. A cedar shower that dries quickly can last decades; one that stays damp can soften in a few seasons, even with good wood.

Floors

Build the floor as a removable slatted deck of 2×4 or 2×6 cedar with gaps of about 1/4 to 3/8 inch between boards so water drops straight through. Set the deck on sleepers over a gravel bed, pavers, or a concrete pad sloped to drain. Being able to lift the floor out for cleaning is a practical bonus.

Walls

Wall boards can run horizontally or vertically. Horizontal boards with small gaps create a classic look and let air pass through; tongue-and-groove gives full privacy but dries slower. Keep the bottom of the walls at least 4 to 6 inches above the floor or grade so splashing water and debris do not wick into the end grain.

Fasteners and Hardware

Cedar extractives react with plain steel and even some galvanized fasteners, causing black streaks and corrosion. Use stainless steel screws and nails, ideally type 316 near coastal salt air, and stainless or powder-coated hinges and latches. Predrill near board ends to prevent splitting.

Accessories finish the space. A cedar bench gives you a place to set a foot while rinsing, while stainless hooks, a slatted shelf for soap, and a teak or cedar towel bar keep items off the wet floor. If you plan to use the shower after dark, choose low-voltage landscape fixtures or wet-location-rated lights installed on a GFCI-protected circuit, and never run an extension cord to an outdoor shower.

Looking to buy Cedar Outdoor Shower? Compare top-rated options.
Shop on Amazon →Browse Our Shop
As an Amazon Associate we earn from qualifying purchases.

Plumbing Options

Outdoor showers range from a simple cold-water hose connection to a fully plumbed hot-and-cold setup.

  1. Cold only: Tie into an existing hose bib with a shower head. Cheapest, fine for rinsing sand off.
  2. Solar or portable heating: A black solar bag or a small solar tank warms water in the sun; output depends heavily on weather.
  3. Hot and cold from the house: The most comfortable option. Supply lines run from the home’s water heater to a mixing valve in the shower.
  4. Tankless water heater: Outdoor-rated units can serve a remote freestanding shower, but they require a proper gas or electrical supply.

Choose a pressure-balancing or thermostatic mixing valve so a flushing toilet indoors does not send a burst of scalding water. Brass or stainless fixtures hold up far better outdoors than chrome-plated plastic. In any climate with freezing winters, design the system so it can be fully drained: shutoffs inside the heated house, frost-free valves, and supply lines sloped so every drop can empty out before the first hard frost.

When to Call a Licensed Plumber

Running new hot-water lines, adding a mixing valve, installing a tankless heater, or connecting to the home’s drain system is work for a licensed plumber in most jurisdictions, and gas or 240-volt electrical connections need a licensed gas fitter or electrician. Permits are commonly required for new supply or drain connections, so check with your local building department before you break ground.

Drainage and Local Rules

Where the water goes is the part many homeowners skip. Common approaches include a gravel bed under the floor, a small dry well filled with stone, or a connection to the home’s drainage system. Local codes differ on whether shower water can be discharged to the ground. Some areas treat it as greywater with specific rules, especially if you use soap and shampoo. Check before you build, and use biodegradable soaps if the water soaks into the soil near gardens.

Whatever the method, grade the surrounding area so runoff flows away from the house foundation, and avoid dumping water where it will pool near walkways and freeze in winter.

Finishing and Maintaining Cedar

You have two paths: let it weather or maintain the color. Untreated cedar turns silver-gray within one or two seasons, which many owners prefer. It still benefits from occasional cleaning to prevent mildew.

To keep the warm tone, apply a penetrating oil-based or water-based exterior finish formulated for cedar, ideally with UV inhibitors and a mildewcide. Avoid film-forming finishes such as varnish, which peel in constantly wet conditions. Expect to reapply every one to two years on exposed surfaces.

  • Monthly in season: Rinse off soap residue and sweep out leaves and sand.
  • Each spring: Scrub with a soft brush and an oxygen-based cleaner, rinse well, and let dry before finishing.
  • Avoid chlorine bleach and high-pressure washing, which can raise the grain and damage the soft wood surface. If you pressure-wash, use a wide fan tip on low pressure held well back from the wood.
  • Each fall: Drain and winterize lines, remove the floor deck if possible, and store fixtures that are not freeze-proof.

What a Cedar Outdoor Shower Costs

Costs depend mainly on size, cedar grade, and plumbing. As rough guidance for planning:

Project Type Typical Range
Prebuilt cedar kit, DIY assembly $1,200-$4,000
DIY wall-mounted, cold or hose-fed $500-$1,500
Custom freestanding, hot and cold, professionally built $4,000-$12,000+

Cedar lumber prices fluctuate, and clear, knot-free grades can cost two or three times as much as knotty grades. Knotty cedar is perfectly functional and gives a rustic look, while clear boards suit a more modern design. Trenching, long supply runs, and drainage work are the biggest wildcards in professional quotes.

Final Planning Checklist

Before you buy lumber, confirm the location, water source, and drainage method; sketch the enclosure with realistic dimensions; and pick your hardware. Choose heartwood for the wet zones, stainless fasteners throughout, a slatted removable floor, and a mixing valve with scald protection. Plan the winter shutdown from day one. Done that way, a cedar outdoor shower becomes one of the most-used upgrades in the yard, and it will age gracefully for many summers.